RAK13102 WisBlock Blues Notecarrier Module Installation Guide
Prerequisite
The modules required before installation include:
- RAK13102
- Blues.IO Notecard (if not bundled with the RAK13102)
- Your choice of WisBlock Base
- Your choice of WisBlock Core
WisBlock Module Installation
The RAK13102 module integrates with the WisBlock platform to provide cellular and GNSS capabilities. It is suitable for tracking applications in areas with LTE-M, NB-IoT, or GSM network coverage.
The RAK13102 module can be mounted to the IO slot of the WisBlock Base and communicates to the WisBlock Core via I2C. Two antennas must be connected to the Notecard in the RAK13102 module as well, one for the GNSS antenna port and one for the cellular antenna port. An external battery (Li-Ion/LiPo 3.7–4.2 V) is also required to power up the module properly. Optionally, you can supply the RAK13102 and WisBlock Base Board through the EX_POWER connector P1 from a regulated 5V DC source.
The RAK13102 module and the connected WisBlock Base Board and Core module can be supplied with a regulated 5 V DC supply through the P1 connector on the bottom. A matching connector is available through the M8 Power Connector
Figure 1: 5V supply through M8 power connector
Figure 1: M8 power connectorAssembling and Disassembling of WisBlock Modules
Assembling
The locations for Slot A, B, C, and D are properly marked by silkscreen. Follow carefully the procedure defined in WisBlock Base module assembly/disassembly instructions to attach a WisBlock module. Once attached, carefully fix the module with one or more pieces of M1.2 x 3 mm screws depending on the module.
Figure 1: RAK13102 connection to WisBlock BaseAssemble the RAK13102 module BEFORE you plug the Blues Notecard in. Otherwise, you cannot reach the screws to fix the IO module on the BaseBoard.
After the RAK13102 module is assembled on the Base Board you can connect the Blues Notecard to the RAK13102. Fix the Notecard on the RAk13102 module with the M3 screw that comes with the RAK13102 module.
Figure 1: Notecard assembly in the RAK13102Disassembling
The procedure in disassembling any type of WisBlock modules is the same.
- First, remove the screws.
Figure 1: Removing screws from the WisBlock module- Once the screws are removed, check the silkscreen of the module to find the correct location where force can be applied.
Figure 1: Finding the proper position to detach the WisBlock module- Apply even force to the module at the position of the connector to detach the module from the WisBlock Base.
Figure 1: Applying even forces on the proper location of a WisBlock moduleIf you will connect other modules to the remaining WisBlock Base slots, check on the WisBlock Pin Mapper tool for possible conflicts.
After all this setup, you can now connect the battery (optional) and USB cable to start programming your WisBlock Core.
- Batteries can cause harm if not handled properly.
- Only 3.7-4.2 V Rechargeable LiPo batteries are supported. It is highly recommended not to use other types of batteries with the system unless you know what you are doing.
- If a non-rechargeable battery is used, it has to be unplugged first before connecting the USB cable to the USB port of the board to configure the device. Not doing so might damage the battery or cause a fire.
- Only 5 V solar panels are supported. Do not use 12 V solar panels. It will destroy the charging unit and eventually other electronic parts.
- Make sure the battery wires match the polarity on the WisBlock Base board. Not all batteries have the same wiring.
Figure 1: WisBlock Base battery polarity and connection