RAK13300 WisBlock LPWAN Wireless Module Installation Guide
Prerequisite
The modules required before installation include:
- RAK13300
- Your choice of WisBlock Base
- RAK11200 WisBlock Core
WisBlock Module Installation
The RAK13300 Wireless module integrates with WisBlock Core modules without a built-in LoRa radio chip, such as the RAK11200. It extends WisBlock applications with LoRa P2P and LoRaWAN connectivity.
RAK13300 module can be mounted to the IO slot of the WisBlock Base and communicated to the WisBlock Core via SPI. The module is activated via WB_IO2 pin of the WisBlock Core.
Figure 1: RAK13300 connection to WisBlock BaseAssembling and Disassembling of WisBlock Modules
Assembling
The location of the IO Slot is properly marked by silkscreen. Follow carefully the procedure defined in WisBlock Base module assembly/disassembly instructions to attach a WisBlock module. Once attached, carefully fix the module with one or more pieces of M1.2 x 3 mm screws depending on the module.
Figure 1: RAK13300 connection to WisBlock BaseDisassembling
The procedure in disassembling any type of WisBlock modules is the same.
- First, remove the screws.
Figure 1: Removing screws from the WisBlock module- Once the screws are removed, check the silkscreen of the module to find the correct location where force can be applied.
Figure 1: Finding the proper position to detach the WisBlock module- Apply even force to the module at the position of the connector to detach the module from the WisBlock Base.
Figure 1: Applying even forces on the proper location of a WisBlock moduleIf you will connect other modules to the remaining WisBlock Base slots, check on the WisBlock Pin Mapper tool for possible conflicts.
After all this setup, you can now connect the battery (optional) and USB cable to start programming your WisBlock Core.
- Batteries can cause harm if not handled properly.
- Only 3.7-4.2 V Rechargeable LiPo batteries are supported. It is highly recommended not to use other types of batteries with the system unless you know what you are doing.
- If a non-rechargeable battery is used, it has to be unplugged first before connecting the USB cable to the USB port of the board to configure the device. Not doing so might damage the battery or cause a fire.
- Only 5 V solar panels are supported. Do not use 12 V solar panels. It will destroy the charging unit and eventually other electronic parts.
- Make sure the battery wires match the polarity on the WisBlock Base board. Not all batteries have the same wiring.
LoRa Antenna
The RAK13300 requires a LoRa Antenna to have a good signal. And do not power the module without an antenna connected to the IPEX connector to avoid damage to the RF section of this chip.
Figure 1: LoRa Antenna
Figure 1: RAK13300 Antenna SlotWhen using the LoRa transceivers, make sure that an antenna is always connected. Using these transceivers without an antenna can damage the system. Make sure to fix the module with the screws to ensure a proper function.
Battery Connection (Optional)
You can power the module via USB Cable or Li-Ion/LiPo battery via connectors. There are other WisBlock Base boards available, and you need to check the datasheet of the specific WisBlock Base board for the right polarity and parameters.
Figure 1: WisBlock Base battery polarity and connection