RAK18060 WisBlock Audio Stereo Amplifier Module Installation Guide
Prerequisite
The modules required before installation include:
- RAK18060 WisBlock Audio Stereo Amplifier Module
- Your choice of WisBlock Base with IO slot
- Your choice of WisBlock Core
WisBlock Module Installation
RAK18060 is a stereo amplifier module, part of the WisBlock Audio Series. It connects to the IO slot of the WisBlock Base to communicate with the WisBlock Core. Always secure the connection of the WisBlock module by using compatible screws.
Select a compatible WisBlock Base and WisBlock Core according to your needs.
Figure 1: RAK18060 connection to WisBlock BaseAssembling and Disassembling of WisBlock Modules
Assembling
The location for the IO slot is properly marked by silkscreen. Follow carefully the procedure defined in WisBlock Base board assembly/disassembly instructions to attach a WisBlock module. Once attached, carefully fix the module with one or more pieces of M1.2 x 3 mm screws depending on the module.
Figure 1: RAK18060 connection to WisBlock BaseDisassembling
The procedure in disassembling any type of WisBlock modules is the same.
- First, remove the screws.
Figure 1: Removing screws from the WisBlock module- Once the screws are removed, check the silkscreen of the module to find the correct location where force can be applied.
Figure 1: Finding the proper position to detach the WisBlock module- Apply even force to the module at the position of the connector to detach the module from the WisBlock Base.
Figure 1: Applying even forces on the proper location of a WisBlock moduleIf you will connect other modules to the remaining WisBlock Base slots, check on the WisBlock Pin Mapper tool for possible conflicts.
After all this setup, you can now connect the battery (optional) and USB cable to start programming your WisBlock Core.
- Batteries can cause harm if not handled properly.
- Only 3.7-4.2 V Rechargeable LiPo batteries are supported. It is highly recommended not to use other types of batteries with the system unless you know what you are doing.
- If a non-rechargeable battery is used, it has to be unplugged first before connecting the USB cable to the USB port of the board to configure the device. Not doing so might damage the battery or cause a fire.
- Only 5 V solar panels are supported. Do not use 12 V solar panels. It will destroy the charging unit and eventually other electronic parts.
- Make sure the battery wires match the polarity on the WisBlock Base board. Not all batteries have the same wiring.
- You need to connect the LoRa and BLE antennas to the RAK4631 module to avoid damage to this module during operation.
Figure 1: LoRa and BLE antennas connection to RAK4631 module- There are different power sources possible for the RAK18060. By default, the power source is the battery on the WisBlock Base board. You should see a solder blob on SB2 on the circuit board of RAK18060.
Figure 1: Power Select Diagram for RAK18060
Figure 1: Solder portion for SB2 of RAK18060- Then you can now connect the speaker on either output of the RAK18060 module.
Figure 1: Speaker output portions of RAK18060 module