RAK19012 WisBlock USB LiPo Solar Power Slot Module Installation Guide
The RAK19012 should be attached to the power slot connector of a WisBlock Base board with a power slot. It is a power board providing the same features and interfaces as standard WisBlock Base boards: a USB-C connector, battery and solar panel connectors, LED indicators, and a reset button.
RAK19012 only supports WisBlock Base boards with Power Slot. It is not compatible with all WisBlock Base boards.
Prerequisite
Required items for RAK19012 setup include:
- RAK19012 WisBlock USB LiPo Solar Power Slot Module
- A compatible WisBlock Base Board with Power Slot
- A compatible WisBlock Core
- Li-Ion/LiPo battery (optional)
- Solar panel connector cable (optional)
WisBlock WisConnector Installation
Attach a WisConnector
WisBlock Power modules are installed in the dedicated Power Slot of compatible WisBlock Base Boards. Secure the installed module using compatible screws to ensure a reliable mechanical connection.
Figure 1: RAK19013 mounting connection to WisBlock Base moduleDetach a WisConnector
The procedure for disassembling any type of WisBlock module is the same.
- First, remove the screws.
Figure 1: Removing screws from the WisBlock module- Once the screws are removed, check the module's silkscreen to find the correct location for applying force.
Figure 1: Detach silkscreen on the WisBlock module-
Apply even force to the marked connector area on the module PCB to detach the module from the Base Board.
Figure 1: Applying even forces on the proper location of a WisBlock module
Battery Selector
Rechargeable Battery
RAK19012 can be powered by a rechargeable Li-ion/LiPo battery via the dedicated connectors. The matching connector for the rechargeable battery wires is a JST PHR-2 2 mm pitch female . A cable assembly for the rechargeable battery connector is also available for purchase in RAK store .
The voltage of the battery must not exceed 4.3 V.
- Batteries can cause harm if not handled properly.
- Only 3.7 V-4.2 V rechargeable LiPo batteries are supported. It is highly recommended not to use other types of batteries with the system unless you are familiar with the risks.
- Ensure the battery wires, both rechargeable and non-rechargeable, match the polarity on the RAK19012 board. Not all batteries have the same wiring.
Solar Panel Connection
The battery can be recharged, as well, via a small Solar Panel. The matching connector for the solar panel wires is an JST ZHR-2 1.5 mm pitch female . A cable assembly for the solar panel connector is also available for purchase in RAK store .
- Only 5 V solar panels are supported. Do not use 12 V solar panels. It will destroy the charging unit and eventually other electronic parts.
- The GND pin of the solar panel connector is located on edge of the board. Ensure the solar panel wires match the polarity on the RAK19012 board.
