RAK19015 WisBlock Battery Power Slot Module Installation Guide
The RAK19015 WisBlock Battery Power Slot Module is a power board that consists of a battery connector, a reset push button, and a power connector that can connect with the WisBlock Base board.
Prerequisite
Required items for RAK19015 setup include:
- RAK19015 WisBlock Battery Power Slot Module
- A compatible WisBlock Base Board with Power Slot
- A compatible WisBlock Core
- Li-Ion/LiPo battery (optional)
- RAK5804 WisBlock Interface Module (Reprogramming of the WisBlock Core via USB)
RAK19015 Connection to WisBlock Base
Connection to WisBlock Base
The voltage of the battery must not exceed 4.3 V.
Connection to WisBlock Base with RAK5804
Since there is no USB on RAK19015, the only way to upload the code is by using RAK5804 .
WisBlock WisConnector Installation
Attach a WisConnector
WisBlock Power modules are installed in the dedicated Power Slot of compatible WisBlock Base Boards. Secure the installed module using compatible screws to ensure a reliable mechanical connection.
Figure 1: RAK19013 mounting connection to WisBlock Base moduleDetach a WisConnector
The procedure for disassembling any type of WisBlock module is the same.
- First, remove the screws.
Figure 1: Removing screws from the WisBlock module- Once the screws are removed, check the module's silkscreen to find the correct location for applying force.
Figure 1: Detach silkscreen on the WisBlock module-
Apply even force to the marked connector area on the module PCB to detach the module from the Base Board.
Figure 1: Applying even forces on the proper location of a WisBlock module
Battery Connector
Rechargeable Battery
RAK19015 WisBlock Battery Power Slot Module can be powered by a rechargeable Li-Ion/LiPo battery via the dedicated connectors. The matching connector for the rechargeable battery wires is a JST PHR-2 2 mm pitch female . A cable assembly for the rechargeable battery connector is also available for purchase in RAK store .
- Improper handling of the battery can be harmful.
- 3.7 ~ 4.2 V Li-Ion batteries are primarily supported. It is highly recommended not to use other types of batteries with the system unless you know what you are doing.
- Make sure the battery wires, both rechargeable and non-rechargeable, match the polarity on the RAK19015 board. Not all batteries have the same wiring.
