RAK19016 WisBlock 5-24 V Power Slot Module Installation Guide
Prerequisite
Required items for RAK19016 setup include:
- RAK19016 WisBlock 5-24 V Power Slot Module
- A compatible WisBlock Base Board with Power Slot
- A compatible WisBlock Core
- 5–24 VDC external power source
- Li-Ion/LiPo battery (optional)
- RAK5804 WisBlock Interface Module (Reprogramming of the WisBlock Core via USB of RAK5804)
RAK19016 Connection to WisBlock Base
RAK19016 should be attached to the power slot connector of WisBlock Base board with power slot. The 5~24 VDC input voltage must be connected to the 3-pin screw terminal connector. The LiPo/Li-Ion battery can be connected to the standard battery connector.
RAK19016 only supports WisBlock Base boards with power slot. It is not compatible with all WisBlock Base boards.
Connection to WisBlock Base board with Power Slot
The voltage of the battery must not exceed 4.3 V.
Connection to WisBlock Base with RAK5804
Since there is no USB connector on RAK19016, the only way to upload the code is by using RAK5804.
WisBlock WisConnector Installation
Attach a WisConnector
WisBlock Power modules are installed in the dedicated Power Slot of compatible WisBlock Base Boards. Secure the installed module using compatible screws to ensure a reliable mechanical connection.
Figure 1: RAK19013 mounting connection to WisBlock Base moduleDetach a WisConnector
The procedure for disassembling any type of WisBlock module is the same.
- First, remove the screws.
Figure 1: Removing screws from the WisBlock module- Once the screws are removed, check the module's silkscreen to find the correct location for applying force.
Figure 1: Detach silkscreen on the WisBlock module-
Apply even force to the marked connector area on the module PCB to detach the module from the Base Board.
Figure 1: Applying even forces on the proper location of a WisBlock module
Battery Connection
RAK19016 supports a rechargeable Li-Ion/LiPo battery via the dedicated connector. The battery and external 524 VDC input can simultaneously be connected to provide power to all WisBlock modules. The 524 VDC goes to a buck converter with 4.4 VDC output which is higher than the max 4.2 VDC of LiPo battery. 5~24 VDC is the primary power source and also charges the LiPo battery at the same time.
The matching connector for the rechargeable battery wires is a JST PHR-2 2 mm pitch female . A cable assembly for the rechargeable battery connector is also available for purchase in RAK store.
- Improper handling of the battery can be harmful.
- Only 3.7~4.2 V rechargeable LiPo batteries are supported. It is highly recommended not to use other types of batteries with the system unless you know what you are doing.
- Make sure the battery wires, both rechargeable and non-rechargeable, match the polarity on the RAK19016 board. Not all batteries have the same wiring.
