Skip to main content
X

Helium Mounting Kit Installation Guide

Kit Inclusion​

  1. Roof Mounting Pole

    • Mounting Poles
    • Mounting Base
    • Antenna Mounting Bracket
    • Screws

  2. Wall Mounting Pole

    • Mounting Poles
    • Antenna Mounting Bracket
    • Screws

  3. Concrete Ground Mounting Pole

    • Mounting Poles
    • Antenna Mounting Bracket
    • Screws

Preparation​

During installation, ensure that the installer complies with all the necessary safety regulations to ensure personal safety.

warning

Do not place equipment and mounting kit on pedestrian walkways to avoid accidental damage to the equipment.

Installation​

NOTE

The diameter of the pole that is supported by the brackets is 22-32 mm. If the pole diameter is less than this value, you can add a thicker rubber pad to it.

Fix the Base Mast​

Before you begin the assembly, you should know its final location. According to your location, there are three options for installation: roof mounting, fixing on the concrete ground, and fixing on the wall.

Figure 262: Mounting options

Roof Mounting​

  1. The base of the roof mount kit is made from five-seven pieces of angle steel. Attach the outer and middle two pieces by inserting M8 carriage bolts from outside and secure each with a washer, lock washer, and nut. Keep these finger-tight until completing the base assembly.
Figure 263: Attaching the angle steel using the carriage bolts
  1. Attach the other two pieces by inserting M8 carriage bolts from outside and secure each with a washer, lock washer, and nut. Fix all the nuts with a wrench.
Figure 264: Attaching the other two angle steel using the carriage bolts
  1. Attach the mast by inserting M8 carriage bolts from underneath and secure each with a washer, lock washer, and nut. Then fix all the nuts with a wrench.
Figure 265: Attaching the mast
  1. Secure the base by placing cinder blocks in the base.
Figure 266: Placing the cinder blocks

Concrete Ground Mounting​

  1. Drill 12 mm holes on the concrete ground and insert four anchors in the hole.
Figure 267: Drilling the concrete ground
  1. Attach the mast and secure each with a washer, lock washer, and nut. Fix all the nuts with a wrench.
Figure 268: Attaching the mast

Wall Mounting​

  1. Drill 12 mm holes on the wall and insert four anchors in the hole.
Figure 269: Drill holes on the wall
  1. Attach the mast and secure each with a washer, lock washer, and nut. Fix all the nuts with a wrench.
Figure 270: Attach the mast
  1. Install the antenna fixing pole or the extension pole according to the requirements:
    • Height without extension pole: 1.4 m
    • Height with extension pole: 2.1 m
Figure 271: Install the extension pole
Figure 272: Install the extension pole

Install the Antennas​

  1. Attach the four antenna clamps with M4 screws. Keep the gap for the antenna.
Figure 273: Attach the antenna clamps
  1. Insert the four antennas into the gap and tighten all the screws.
Figure 274: Install the antennas
Figure 275: Install the antennas

Install the Base Station​

Install the base station or gateway on the pole. Refer to the installation guides of the device for installation steps.

Figure 276: Install the base station

Attach the Connector Sheath​

Put the connector sheath on both ends of the RF coaxial cable.

Figure 277: Connector sheath on the RF coaxial cable

Connect the RF coaxial cables​

Connect the RF coaxial cables to the ports on the device and antenna.

Figure 278: RF coaxial cables into the device and antenna

Lift the Sheath​

Lastly, lift the sheath onto the connector.

Figure 279: Lift the sheath