WisBlock RAKBox-B6 Enclosure Installation Guide
Assembly List
Figure 1: Assembly ListAssembly
- Fix the core and sensor modules to the WisBlock Base with an appropriate number of M1.2*3 screws. For assembly methods and precautions, refer to the WisBlock Base Board Installation Guide.
Figure 1: Attach Core and Sensor Modules- Put the battery in the space between four stand-offs of the enclosure.
NOTE
Ensure the battery dimensions are less than 65 mm x 44 mm x 8 mm to fit the enclosure.
Figure 1: Battery Assembly- Fix the mounting plate onto the enclosure using tapping screws.
Figure 1: Fix Mounting Plate- Install the WisBlock modules with four M2.5*4 screws.
Figure 1: Fix WisBlock Base Board- Stick the antenna to the sidewall of the enclosure and connect the antenna wire to the IPEX connector.
Figure 1: Antenna Installation- Plug the terminal of the battery into the socket of the WisBlock module. Then, assemble the lid.
warning
Make sure the voltage polarity of the battery's connector matches with the voltage polarity of the connector on the WisBlock Base Board. The + wire from the battery must match the + sign next to the battery connector.
Figure 1: Close the LidInstallation
- Use a Ø5 mm drill head and drill two holes in the wall according to the dimensions shown in Figure 8:
Figure 1: Drill Holes- Install the screw anchor into the wall, then install the screw into the anchor, leaving about 3 mm between the screw head and wall.
Figure 1: Install Screws- Insert the screw head into the mounting hole at the back of the enclosure, then gently pull the enclosure downward to complete the installation.
Figure 1: Install Enclosure on Wall
