Firmware Upgrade

This section guides you through the process of checking and upgrading the firmware on your WisGateOS 2 gateway.

Check the Firmware Version

Go to Settings> Firmware to view the current firmware version.

Figure 1: Firmware tab

Firmware Upgrade

Before You Upgrade

Backup Before Any Upgrade

Before performing any firmware upgrade, it is highly recommended to create a full backup of your configuration. This ensures you can restore your settings in case of unexpected issues or if a reset is required.

For detailed steps on how to back up your configuration, refer to Backup Configuration.

Upgrade to WisGateOS 2.2.x

When upgrading from WisGateOS 2.1.x or earlier to 2.2.x, take note of the following important considerations:

• Downgrading Restrictions
  After upgrading to WisGateOS 2.2.x, reverting to version 2.1.x through the standard downgrade method (WebUI) is not possible. Make sure that all critical data is backed up before proceeding with the upgrade.

  Downgrading is only possible through a recovery procedure. For details, see OpenWRT Recovery Procedure on the RAK Learn site.

• Extension Signature Requirement
  Starting with WisGateOS 2.2.x, all official extensions are released with valid signatures to maintain security and compatibility. The system still allows uploading custom extensions without signatures, mainly for development or customization purposes.

  Unsigned extensions installed before the upgrade remain functional and do not require reinstallation.

• Internet Connection Requirement
  An Internet connection is required during the upgrade to verify the new firmware and extension signatures.

• Dual Firmware Support
  Both 2.1.x and 2.2.x will be supported. Make sure the correct extensions for each version to avoid compatibility issues.

Upgrade Steps

warning

Do not disconnect the power during the gateway upgrade.

1. Download the latest version of the WisGateOS 2 firmware for the gateway and unzip the file.
2. Drag and drop the .rwi file in the Drop your RWI file here or choose file form, or click the choose file link to browse for the file.
3. Check the Keep settings after updating option.
   Figure 1: Upload the firmware file
   NOTE

   The Keep settings after updating check box is selected by default. Unchecking it will reset the gateway to stock settings after the upgrade.

4. Click Update to initiate the firmware flashing process.
   Figure 1: Upgrading
5. After the upgrade is complete, log in to the gateway and check the Firmware tab to confirm that the installed firmware version is correct.

Troubleshooting

WisDM Firmware Upgrade Management

When the gateway is integrated with WisDM and FOTA is enabled, the firmware upgrade is managed remotely by WisDM.

Figure 1: Firmware tab inactive

To enable firmware upgrades through the gateway:

1. Navigate to the WisDM tab.
2. Disable the Enable FOTA option.
3. Save the changes.

Once FOTA is disabled, the Firmware tab will becomes active, allowing you to perform the firmware upgrade.

NOTE

Disabling FOTA will prevent the gateway from receiving automatic firmware updates via WisDM and allow you to manage the firmware updates directly through WisGateOS.