RAK13101 WisBlock GSM/GPRS Module Installation Guide
Prerequisite
The modules required before installation include:
- RAK13101
- Your choice of WisBlock Base
- Your choice of WisBlock Core
To use a RAK13101, you need at least a WisBlock Base with IO slot to plug the module in and a dedicated battery because the USB current from your PC won't be enough to power the Quectel MC20CE during cellular transmissions. Furthermore, you need a WisBlock Core module to use the cellular module and a sim card that works in your location.
WisBlock Module Installation
The RAK13101 module integrates with the WisBlock platform to extend its functionality with GSM, GPRS, and GNSS capabilities. It is suitable for tracking applications requiring cellular connectivity and GNSS positioning.
RAK13101 module can be mounted to the IO slot of the WisBlock Base and communicates to the WisBlock Core via UART. The module is activated via WB_IO5 pin of the WisBlock Core. Two antennas must be connected to the module as well, one for the GNSS antenna port and one for the GSM antenna port. An external battery (Li-Ion/LiPo 3.7-4.2V) is also required to power up the module properly.
Figure 1: RAK13101 connection to WisBlock Base
Figure 1: WisBlock Base battery polarity and connectionAssembling and Disassembling of WisBlock Modules
Assembling
The location for Slot A, B, C, and D are properly marked by silkscreen. Follow carefully the procedure defined in WisBlock Base module assembly/disassembly instructions to attach a WisBlock module. Once attached, carefully fix the module with one or more pieces of M1.2 x 3 mm screws depending on the module.
Figure 1: RAK13101 connection to WisBlock BaseDisassembling
The procedure in disassembling any type of WisBlock modules is the same.
- First, remove the screws.
Figure 1: Removing screws from the WisBlock module- Once the screws are removed, check the silkscreen of the module to find the correct location where force can be applied.
Figure 1: Finding the proper position to detach the WisBlock module- Apply even force to the module at the position of the connector to detach the module from the WisBlock Base.
Figure 1: Applying even forces on the proper location of a WisBlock moduleIf you will connect other modules to the remaining WisBlock Base slots, check on the WisBlock Pin Mapper tool for possible conflicts.
After all this setup, you can now connect the battery (optional) and USB cable to start programming your WisBlock Core.
- Batteries can cause harm if not handled properly.
- Only 3.7-4.2 V Rechargeable LiPo batteries are supported. It is highly recommended not to use other types of batteries with the system unless you know what you are doing.
- If a non-rechargeable battery is used, it has to be unplugged first before connecting the USB cable to the USB port of the board to configure the device. Not doing so might damage the battery or cause a fire.
- Only 5 V solar panels are supported. Do not use 12 V solar panels. It will destroy the charging unit and eventually other electronic parts.
- Make sure the battery wires match the polarity on the WisBlock Base board. Not all batteries have the same wiring.
