RAK14008 WisBlock Gesture Sensor Module Installation Guide
RAK14008 is a gesture sensor module based on PAJ7620U2. It is designed for gesture recognition applications with an I2C digital interface. It can recognize nine (9) human hand gesticulations such as moving up, down, left, right, forward, backward, circle-clockwise, circle-counter clockwise, and waving. It also offers built-in proximity detection in sensing approaching or departing objects from the sensor.
Prerequisite
The modules required before installation include:
- RAK14008 WisBlock Gesture Sensor Module
- A WisBlock Base with an IO slot
- Your choice of WisBlock Core
- RAK19008 WisBlock IO Extension Cable (optional)
WisBlock Module Installation
Connect the RAK14008 to the IO slot of a WisBlock Base to communicate with the WisBlock Core, and secure the module with compatible screws.
Select a compatible WisBlock Base and WisBlock Core according to the module's interface, slot, power, and software requirements.
Figure 1: RAK14008 connection to WisBlock BaseAssembling and Disassembling of WisBlock Modules
Assembling
The RAK14008 module can be mounted on the IO slot of the Wis WisBlock Base board. Also, always secure the connection of the WisBlock module by using compatible screws.
Figure 1: RAK14008 mounting connection to WisBlock Base moduleDisassembling
The procedure in disassembling any type of WisBlock modules is the same.
- First, remove the screws.
Figure 1: Removing screws from the WisBlock module- Once the screws are removed, check the silkscreen of the module to find the correct location where force can be applied.
Figure 1: Finding the proper position to detach the WisBlock module- Apply even force to the module at the position of the connector to detach the module from the WisBlock Base.
Figure 1: Applying even forces on the proper location of a WisBlock moduleIf you will connect other modules to the remaining WisBlock Base slots, check on the WisBlock Pin Mapper tool for possible conflicts.
After all this setup, you can now connect the battery (optional) and USB cable to start programming your WisBlock Core.
- Batteries can cause harm if not handled properly.
- Only 3.7-4.2 V Rechargeable LiPo batteries are supported. It is highly recommended not to use other types of batteries with the system unless you know what you are doing.
- If a non-rechargeable battery is used, it has to be unplugged first before connecting the USB cable to the USB port of the board to configure the device. Not doing so might damage the battery or cause a fire.
- Only 5 V solar panels are supported. Do not use 12 V solar panels. It will destroy the charging unit and eventually other electronic parts.
- Make sure the battery wires match the polarity on the WisBlock Base board. Not all batteries have the same wiring.
