RAK5860 WisBlock NB-IoT Interface Module Installation Guide
Prerequisite
The modules required before installation include:
- RAK5860
- Your choice of WisBlock Base
- Your choice of WisBlock Core
To use a RAK5860, you need at least a WisBlock Base to plug the module in. WisBlock Base is the power supply for the RAK5860 module. Furthermore, you need a WisBlock Core module to use the sensor.
- A battery connected to the WisBlock Base is required. USB power is not enough to make the module work reliably.
- You must be in an area or location where LTE-M and NB-IoT service is available. Otherwise, RAK5860 will not work.
- When using the BG77 Cellular modules, always make sure that an antenna is connected. Using the transceiver without an antenna can damage the system.
- The included active GPS antenna must be connected to the iPEX antenna connector on the board. Otherwise, the module will not work.
- Make sure to fix the module with screws to ensure proper function.
WisBlock Module Installation
RAK5860 module can be mounted to the IO slot of the WisBlock Base and communicates with the WisBlock Core via UART. The module is activated via WB_IO1 pin of the WisBlock Core. Two antennas must also be connected to the module, one for the GNSS antenna port and one for the Cellular antenna port. An external battery (Li-Ion/LiPo 3.7-4.2 V) is also required to power up the module properly.
Figure 1: RAK5860 connection to WisBlock Base
Figure 1: WisBlock Base battery polarity and connectionAssembling and Disassembling of WisBlock Modules
Assembling
The location for the module slots is properly marked by silkscreen. Follow the procedure defined in theWisBlock Base module assembly/disassembly instructions to attach a WisBlock module. Once attached, carefully fix the module with one or more pieces of M1.2 x 3 mm screws, depending on the module.
Figure 1: RAK5860 connection to WisBlock BaseDisassembling
The procedure in disassembling any type of WisBlock modules is the same.
- First, remove the screws.
Figure 1: Removing screws from the WisBlock module- Once the screws are removed, check the silkscreen of the module to find the correct location where force can be applied.
Figure 1: Finding the proper position to detach the WisBlock module- Apply even force to the module at the position of the connector to detach the module from the WisBlock Base.
Figure 1: Applying even forces on the proper location of a WisBlock moduleIf you will connect other modules to the remaining WisBlock Base slots, check on the WisBlock Pin Mapper tool for possible conflicts.
After all this setup, you can now connect the battery (optional) and USB cable to start programming your WisBlock Core.
- Batteries can cause harm if not handled properly.
- Only 3.7-4.2 V Rechargeable LiPo batteries are supported. It is highly recommended not to use other types of batteries with the system unless you know what you are doing.
- If a non-rechargeable battery is used, it has to be unplugged first before connecting the USB cable to the USB port of the board to configure the device. Not doing so might damage the battery or cause a fire.
- Only 5 V solar panels are supported. Do not use 12 V solar panels. It will destroy the charging unit and eventually other electronic parts.
- Make sure the battery wires match the polarity on the WisBlock Base board. Not all batteries have the same wiring.
