RAK5146 WisLink LPWAN Concentrator Installation Guide
Prerequisites
The following sections list the components and tools required to get started with the development board. Some of these items are included in the package, while others must be provided separately.
Hardware Tools
- RAK5146 WisLink LPWAN Concentrator
- Raspberry Pi 3/4 (RAK5146 bundle includes a Raspberry Pi 3 or 4)
- RAK5146 Pi HAT (RAK5146 bundle includes a RAK5146 Pi HAT)
- LoRa and GPS antennas
- A 16 GB SD card (included in the RAK5146 bundle only), a card reader, and a PC
Software Tools
- Balena Etcher: a tool for burning the firmware on the SD card
- Latest RAK5146 Firmware
Device Firmware Setup
For an easy and quick way of having a fully functional gateway, a Precompiled Firmware Image is provided. This section gives you step-by-step instructions on how to install the Image into your SD Card used for the gateway.
Burn the Latest Firmware
- Download the latest firmware of RAK5146, which is based on the Raspbian OS.
- Use an image writing tool to install the firmware on the SD card. For this tutorial, Etcher, an open-source utility for burning image files, will be used.
- Insert your SD Card into the SD Card reader and plug it into your computer.
- Open the balenaEtcher Software, and select the downloaded image file in the first section of the balenaEtcher.
The SD card should be automatically detected by the Etcher software. If not, secure a proper connection.
Click Flash and wait for a couple of minutes until it displays Flash Complete.
Figure 1: Balena Etcher SoftwareAssembly Guide
To create a functioning RAK5146 WisLink LPWAN Concentrator, put these several components together.
Mount the Concentrator
- Insert your RAK5146 mPCIe card into the mPCIe slot on the RAK2287/RAK5146 Pi HAT. Make sure the card fits securely into the connector and sticks out at a 45-degree angle.
- Gently press it down and fasten it with 2 screws. Use Figure 2 as a reference.
If you have positioned the card correctly, the screw holes on the RAK2287 will match the ones on the RAK2287/RAK5146 Pi HAT.
Figure 1: Assembly of the Concentrator and the HATAntennas
The module includes with two antennas: GPS, and LoRa. Both are equipped with pigtail cables that have uFL connectors, which fit onto the corresponding ports on the RAK5146. These ports are clearly labeled. Match each antenna to its appropriate port and gently press until the connectors securely fit together.
It is not recommended to power the device with the antennas detached, as this might damage the circuitry.
Mount the HAT
Take the RAK2287/RAK5146 Pi HAT, which now has the RAK5146 securely mounted on top, and place it over the Raspberry Pi. Both the Pi and the HAT have a 40-pin connector that should align and fit together when pressed on top of each other.
SD Card
Insert the SD card with the Firmware you flashed in the previous step into the SD card slot on the bottom of the Raspberry Pi.
Boot
Power the Raspberry Pi using the Micro USB port (Pi3) or the USB Type-C port (Pi4). As this is the first time booting the OS, it may take a few minutes for everything to set up.
It is recommended to use at least a 2.5 A (for Raspberry Pi 3B+) or a 3 A (for Raspberry Pi 4) power supply.
