RAK3372 WisBlock LPWAN Module AT Command Manual

Overview

The RAK3372 simplifies integrating LoRa technology into your projects by providing an easy-to-use Serial Port communication interface for sending AT commands. These commands allow you to configure the parameters required for LoRa P2P and LoRaWAN communication.

RUI3 AT Command List

The RAK3372 default firmware is based on RUI3 (RAKwireless Unified Interface V3). You can access the AT command via UART2 by default (and also possible via UART1). RAK3372 Quick Start Guide miscellaneous section

The complete list of commands can be found in RUI3 AT Commands Documentation.

NOTE

UART1 and UART2 modes of operation and its configuration can be found on RUI3 Serial Operating Modes. Both UARTs can be configured in Binary Mode as well.