Mount the Raspberry Pi Compute Module 4 to the underside of the RAKR314 base board. Ensure the connectors are properly aligned, then gently press the two modules together until they click into place. Secure the CM4 module using the provided mounting screws.
Figure 1: Put together the CM4 and the RAKR314
Place the assembled RAKR314 onto the bottom plate of the enclosure, align it properly, and secure it using screws.
Figure 1: Fix the RAKR314 to the bottom plate
Place the outer casing around the board and attach the bottom plate with the assembled RAKR314 securely in place.
Figure 1: Fit the outer casing
Place the top plate and screw it in place.
Figure 1: Fix the top of the enclosure
The kit includes pre-drilled holes for antennas, which are useful if you are using additional HATs such as the RAK5146 HAT for LoRaWAN or the RAK2013 HAT for cellular connectivity. If these holes are not needed, you can cover them with the provided rubber caps. Additionally, unused ports on the side of the enclosure can be concealed using the provided sticker.
Figure 1: Cover unused openings
LoRa® is a registered trademark or service mark of Semtech Corporation or its affiliates. LoRaWAN® is a licensed mark.