RAK2287 WisLink LPWAN Concentrator Installation Guide
Prerequisites
The following two sections provide a list of the components and tools you need to get started with the development board. Some of those are included in the package, while others you need to provide yourself.
Hardware Tools
- RAK2287 WisLink LPWAN Concentrator
- Raspberry Pi 3/4 (RAK2287 bundle includes a Raspberry Pi 4)
- RAK2287 Pi HAT (RAK2287 bundle includes a RAK2287 Pi HAT)
- LoRa and GPS antennas
- A 16 GB SD card (included in the RAK2287 bundle only), a card reader, and a PC
Software Tools
- Balena Etcher: a tool for burning the firmware on the SD card
- Latest RAK2287 Firmware
Prepare the Firmware Image
For an easy and quick way of setting up RAK2287 with a Raspberry Pi, a Precompiled Firmware Image is provided.
This section explains how to install the image into the SD Card used for the setup.
Burn the Latest Firmware
-
Download the latest firmware of RAK2287, which is based on the Raspbian OS.
-
Use an image writing tool to install the firmware on the SD Card. For this tutorial, you will use Etcher, an open-source utility used for burning image files.
-
Insert your SD Card into the SD Card reader and connect it to your computer.
-
Open the Etcher Software and select the downloaded image file.
The SD card should be automatically detected by the Etcher software. If not, ensure the SD card is properly connected.
Click Flash and wait until it displays "Flash Complete."
Figure 1: Balena Etcher SoftwareAssemble the RAK2287
To create a functioning RAK2287 WisLink LPWAN Concentrator setup, you need to assemble several components together.
Mount the Concentrator
Insert your RAK2287 mPCIe card into the mPCIe slot on the RAK2003 Pi HAT.
Ensure the card fits securely into the connector, and it should end up sticking out at a 45-degree angle.
Gently press it down and fasten it with two screws. If positioned correctly, the screw holes on the RAK2287 will match the ones on the RAK2003.
Figure 1: Assembly of the Concentrator and the HATConnect the Antennas
The module includes two antennas: GPS and LoRa.
Both antennas are equipped with pigtail cables that feature uFL connectors, which are compatible with the corresponding ports on the RAK2287.
Match each antenna to its appropriate port and gently press until the connectors securely fit together.
It is not recommended to power the device with the antennas detached, as this might damage the circuitry.
Mount the HAT
Take the RAK2003, which now has the RAK2287 securely mounted on top, and place it over the Raspberry Pi.
Both the Pi and the HAT have a 40-pin connector that should align and fit together when pressed on top of each other.
Insert the SD Card
Insert the SD card with the firmware image prepared in the previous step into the SD card slot on the bottom of the Raspberry Pi.
Boot
Power the Raspberry Pi using the Micro USB port (Pi3) or the USB Type-C port (Pi4).As this is the first time booting the OS, it may take a few minutes for everything to set up.
It is recommended to use at least a 2 A power supply.
