RAK5010-BG95 WisTrio NB-IoT Tracker Pro AT Command Manual

The purpose of this section is to demonstrate how to configure the RAK5010 Wistrio NB-IoT Tracker thru the use of AT Commands via a Serial Port Tool running on your Windows PC. The list below shows the AT Commands available for use:

NOTE

You need a serial port tool that can support DTR functions, like Termite. You can download Termite on their website.

For Linux and MacOS, the alternative is Coolterm.

AT Command	Description
at+version	Get the current firmware version number.
at+set_config=device:restart	After set, the device will restart.
at+get_config=device:status	Get all information about the device’s hardware components and their current status.
at+set_config=device:sleep:X	After set, the device will go to sleep or wake up immediately. • 1 - sleep • 0 - wake up
at+set_config=device:cellular:X	• X - 0: close, 1: open
at+set_config=cellular:send_interval:X:Y	Set the interval of sending packet loop. • X - 0: off, 1: on. • Y - The interval time (ms) This value must be more than 150000 (150 s). If the X is set to 1, it means that the device will sleep for Y ms after sending a packet automatically in a loop until you set X to 0.
at+scan=cellular	Scan the around Cellular networks.
at+set_config=cellular:XXX:Y:ZZZ:AAA:BBB:C	Set the IP address and port which you want to send data through Cellular. • XXX - The IP address you want to send data to. • Y - The port you want to send data to. • ZZZ - The cellular operator’s long name you want to connect, for example: CHINA MOBILE. • AAA - The short name of the Cellular operator, for example: CMCC. • BBB - The operator’s APN name, for example CMNET. • C - The number of the Cellular network type. For example, 0 indicates GSM, 8 indicates LTE cat.M1, and 9 indicates LTE cat.NB1.
at+set_config=cellular:(XXX)	Set the Cellular module using the Cellular module’s common AT commands which come from its manufacturer. • XXX - The Cellular module’s common AT commands. For the full list of supported Quectel BG95-M3 AT Commands, check their website.
at+send=cellular:XXX	Send a data through cellular. • XXX - The data you want to send.
at+set_config=hologram:XXX	Configure the Hologram SIM card. • XXX - The device key of the Hologram SIM card. You can find it on Hologram web page after activating the Hologram SIM card.
at+send=hologram:user:XXX	Send a data to Hologram server. • XXX - The data you want to send.
at+send=hologram:sensor	Send a packet of the current sensor’s data to the Hologram server.
at+set_config=ble:work_mode:X:Y	Set the work mode for BLE. • X - 0: BLE peripheral mode, 1: BLE central mode, 2: Beacon scan mode • Y - 0: normal range, 1: BLE long range For more information, refer to the BLE Connection Modes section.